Knowledge Base
Welcome to OPAL-RT’s Knowledge Base
OPAL-RT offers a repository of support information for optimal use of its technology.
Please note that OPAL-RT knowledge base is not fully optimized for mobile platforms.
For optimal experience, use a desktop computer.
Reference Number: AA-01941// Views: AA-01941// Created: 2020-08-14 03:34:23// Last Updated: 2020-08-14 03:59:12 HowTo How to set zero-sequence impedance to Network Sources on Hypersim How to set zero-sequence impedance to Network Sources on Hypersim This article will show you how to set zero-sequence impedance to Network Sources on Hypersim. If you have values for network sources with zero-sequence impedance to implement in Hypersim, or you need to equivalently transfer a model from PSCAD model with zero-sequence sources to Hypersim, you could use the following choices: 1. Use the R-L coupled block from a. Put a Networ Source with zeros given for its RLC parameters; b. Put a R-L coupled block from 2. Use the PI section block from a. Put a Network Source with zeros given for its RLC parameters; b. Put a PI section block from |