OP213: Integration of EXata CPS with RT-LAB / HYPERSIM
This course covers the cyber-physical co-simulation setup between Keysight’s EXata CPS and OPAL-RT’s RT-LAB / HYPERSIM. Learn how to install EXata CPS on your computer, license the software, and go through step-by-step examples on how to implement faults, cyber attacks and integrate both software.
GOALS:
- Learn how to install and configure the EXata CPS software
- Go through different step-by-steps showing how to couple the two software
- Implement your first cyber-attacks and analyze the impacts
- Connect an external device to your co-simulation setup
Note: it is highly recommended to start with the course "Knowledge Box: Introduction to Linux, Networks, and more!" before starting the course.
See and request the full training program >
Installation part 5 - Simulator Installation & Configuration
[00:51] System Requirements Verification
[01:37] Verification for 3.4.1 to see if the patch is required
[03:11] Linux Installation
[04:30] Simulator License - Selecting MAC Address to Use
[06:30] Retrieving License from KSM
[06:43] Installing License on Simulator
[07:08] License Verification
[07:43] Simulator Configuration
[07:49] Disabling IPv6
[09:30] Core Isolation
Suggested Content
See and request the full training program >
Reference:
Keysight Care Software page >
Knowledge Base Article about disabling IPv6 (including lines to write) >
