OP205: Power Electronics Real-Time Simulation with eHS
This course is intended for professionals who want to simulate power electronic circuits with our FPGA-based solver: eHS. This toolbox provides the flexibility and speed required for very fast power conversion applications for HIL simulation. Get a preview of the videos within the e-Learning course below.
GOALS:
- Learn how to run power electronic circuits in real-time for HIL applications
- Take advantage of FPGA high performance for solving power electronic circuits in real-time
- Learn how to design your power electronic circuits with the OPAL-RT Schematic Editor
- Learn how to implement a control algorithm on CPU for your power electronic circuits
- Learn how to interface your power electronic circuits design with an external controller
- Learn how to simulate faults on power electronic converter circuits
See and request the full training program >
GOALS:
- Learn how to run power electronic circuits in real-time for HIL applications
- Take advantage of FPGA high performance for solving power electronic circuits in real-time
- Learn how to design your power electronic circuits with the OPAL-RT Schematic Editor
- Learn how to implement a control algorithm on CPU for your power electronic circuits
- Learn how to interface your power electronic circuits design with an external controller
- Learn how to simulate faults on power electronic converter circuits
See and request the full training program >
Circuit Model And Mapping With CPU Model
OP205: Power Electronics Real-Time Simulation with eHS (Video 3)
Table of Contents:
[00:50] Library Browser
[01:13] Three Level Inverter Circuit Design
[01:44] Source Configuration
[02:28] Internal Sinewave Generator Source Configuration
[03:06] Gates Configuration
[03:31] Measurements Configuration
[04:00] Simulator Setup
[04:46] Import Custom Firmware
Table of Contents:
[00:50] Library Browser
[01:13] Three Level Inverter Circuit Design
[01:44] Source Configuration
[02:28] Internal Sinewave Generator Source Configuration
[03:06] Gates Configuration
[03:31] Measurements Configuration
[04:00] Simulator Setup
[04:46] Import Custom Firmware
